Pool Guide

Pool maintenance in spring: Preparing to get back into service

With the arrival of fine weather, it's time to get your pool back into service after the winter. Good preparation will help you avoid the inconvenience of cloudy water or damaged equipment.

Checking and cleaning the pool

Start by removing the winter cover and cleaning it thoroughly before putting it away. Then, remove the impurities that have accumulated in the water using a net and vacuum the pool for a deep clean.

Water analysis and balancing

Test the pH, alkalinity and chlorine level of your water. The pH should be between 7.2 and 7.6 to ensure that the cleaning products are effective. Adjust the levels if necessary with suitable products.

Restarting the filtration system

Restart the pump and filter and check that they are working properly. Clean the filter if necessary and make sure that the water is circulating properly. A good filtration system is essential for maintaining crystal clear water.

Pool maintenance in summer: Keeping the water clean and balanced

In summer, frequent use of the pool and high temperatures encourage the proliferation of algae and bacteria. Rigorous maintenance is essential to avoid cloudy or green water.

Daily cleaning and filtration

Remove leaves and debris from the surface with a net and run the robot cleaner regularly. The filtration time should be half the water temperature in hours (e.g. 14 hours for water at 28°C).

Water treatment

Add chlorine, bromine or a salt treatment depending on your type of pool. Also consider using a preventive algaecide to limit the appearance of algae. Test and adjust the pH every week.

Monitoring the water level

With evaporation and splashing, the water level can drop quickly. Make sure it is always in the middle of the skimmers to ensure proper filtration.

Autumn pool maintenance: Preparing for winter storage

As winter approaches, it is essential to properly prepare your pool to prevent freezing and protect the equipment. You have the choice between active or passive winterisation. Thorough cleaning Vacuum, clean the walls and remove all debris. Backwash the filter to remove impurities before winterising.

Reduce pool activity

Reduce filtration time to a few hours a day if you opt for active winterisation. For passive winterisation, turn the system off completely and add a specific product to prevent the proliferation of algae.

Installation of a winterising tarpaulin

To protect your pool from leaves and impurities, install a solid winterising tarpaulin. This will make it easier to get the pool up and running again in the spring.

Pool maintenance in winter: Protect your pool from frost

If you have chosen passive winterisation, it is important to check your pool from time to time to avoid frost damage.

Checking the water level

If necessary, lower the water level slightly to prevent frost from causing cracks in the pool walls.

Using winterising floats

Place winterising floats to absorb the pressure of the ice and prevent the pool from deforming.

Checking the equipment

Remember to check your plant room and drain the pipes if necessary to avoid frost damage.

Mistakes to avoid for good annual maintenance

Certain actions can damage your swimming pool in the long term. Here are some mistakes to avoid:

• Not regularly testing the pH and the balance of the water.
• Forgetting to clean the filter, which reduces its effectiveness.
• Leaving the water level too low, risking damage to the pump.
• Using too much or too little cleaning product.
• Neglecting the winterising tarpaulin, which makes it more difficult to get back into service.

Maintaining your swimming pool throughout the year requires regular monitoring and actions adapted to each season. By following this advice, you will enjoy clean water and a pool in perfect condition, while extending the life of your equipment. Preventive maintenance helps avoid costly repairs and guarantees a pleasant swim for the whole family.